Winder Motor
Winder Motor
 |
US $10.99
Why Stage 3 engine cooling heat after running a few minutes.?
Dear Sir, I have a machine capacity 450.in injection engine this machine has a pump.if Colling connect with the engine running 30 minutes until it became hot and automatically Travel off.I have check the filter and clean. I have consulted with a motor winder found that the rotor has some damage.now another motor I have changed it again no mark. engine capacity is 3.7 rpm privious 1430.voltage is 380 kW newone delta.the why change i is 4 kW and motor rpm1440.if'm connecting this same problem also after some time is to fire and auto travel maticaly off.Pls tell me what's going to be the cause of overheating.wheather is electric or hydrolic problem. pls guide me
Is WHeR that you get 380 delta v? the engine is not big enough need more horsepower engine is runing at rated or slow check with tachometer on the shaft 3 380 v ph is found mainly in Austraila and 440V rated motor etc can not reach the rated engine speed and is in position to continue the use of armor will burn if you have 380 v then you need 380 V rated motor or a transformer to increase to 440 480 V motor unless all are not commutable
|
|
Gross Motor Skills In Children With Ds $14.20 ... |
|
|
The Virgin Internet Travel Guide $6.99 ... |